IPX56 Rain Spray Test Chamber

To ensure that various electrical and electronic products (such as lamps, enclosures, and electrical components) can withstand exposure to dripping, spraying, splashing, flushing, and soaking during transportation and use, they must undergo simulation testing in waterproof testing equipment. These tests are conducted according to the relevant provisions of international standards IEC 60529 and IEC 60598, based on the required enclosure protection (IP) levels.

Send Inquiry

Description

Test standard

GB2423,38-90, GB4706.32-2004, IEC-5129

Product Technical Parameters

Inner size	1000 × 1000㎜ ×1000mm(LWH)
The sprinkler system:	Water pump, pressure gauge, stationary nozzle holder,
Nozzle Installation	Installed above the two nozzle heads. One piece of IPX5 nozzle and one piece of IP6 spray nozzle. 10-120 ° angle adjustable
Diameter	six points
The inner diameter of the orifice	1 ~ φ6.3mm, IP5 (grade), 2 ~ φ12.5mm, IP6 (grade)
Water pressure	100 ~ 150kpa (by flow regulator)
Spray flow	IP5 (grade) 12.5 ± 1 (L / min), IP6 (grade) 100 ± 5 (L / min)
The turntable	φ500MM speed: 3 ± 1R / min
Water Duration	3,10,30,9999min (adjustable)
Recycling	water circulation system to ensure water recycling
By the water	the top surface of the product
Water pressure	water pressure gauge, water pressure can be displayed
Support	as a test of tempered glass box outdoor waterproof wall, stainless steel square pass as a stent.
The control system	Longhorn company developed a touch-screen control system.

Rain Spray Test Chamber Structural Principle

The basic principles of the design of the device: a water tank located at the bottom right side of the control box by internal stainless steel pumps and pumping pressurized. Then sent to the upper nozzle. Spray the nozzle perpendicular to the turntable on top of the sample, and then scatter the inside of the tank, thereby forming a water circulation system. Pump outlet design flow meters, pressure gauges, solenoid valves, and other control components. Waterproof inner tank mounting speed dial on the control panel.

Construction Material

Nozzle: stainless steel tube
Water tank: SUS#304
Sealing plate material: Just lower glass 5MM thick glass top PC plastic transparent plate.
Frame material: 304 stainless steel square pass, sand surface, IP56 water jetways: sequentially spray, spray from the first to the last, and then from the last spray has been circulating since the test time to stop. Water flow can be observed.

Safety Devices

Power overload, short-circuit protection
Ground protection
Water protection
Prompt information ring the alarm