vacuum Drying Oven

1. Internal dimensions: refer to models’ size table
2. external dimensions: subject to the actual product;
3. Interlayer: the inner chamber is divided into two layers, with 2pcs shelves, which can customized；
4. Viewable window: the door has a tempered glass window, the thickness of the window glass is 19mm, and the specification is about W150*H200mm;
5. Control panel: The operation panel is installed on the right side of the machine (as shown in the figure);
6. Real pump installation: built-in vacuum pump;
7. The inner material: 304# stainless steel industrial plate, with a thickness of 3mm, internal strengthening treatment, and no deformation after vacuuming;
8. The outer material: a cold-rolled steel plate with a thickness of 1.0mm, powder paint treatment (beige white);
9. Hollow filling material: rock wool, good heat preservation effect;
10. The door sealing material: high-temperature resistant silicone strip;
11. Machine structure: one-piece type, the upper part of the product box and control panel, the lower part is the vacuum pump installation place;
12. Vacuum degree: -100kpa (no vacuum pumping above 100 degrees);
13. Temperature range: RT+30~200 ℃;
14. Load of shelf: below 20kg;
15. Controller: This can be a digital or touchscreen control design.

1. The machine adopts a high-density silicone sealing strip to make the machine have good sealing performance;
2. At the same time, a Panasonic digital display vacuum gauge is used to display the instant relative vacuum degree in the chamber (as shown in the figure);
3. Vacuum pressure-keeping timing: if the pressure-keeping timing control is needed after the vacuum is reached, just turn on the timer, and the alarm will prompt when the time is up, and it will be turned off if not needed;
4. The vacuum control mode: automatic control, which automatically stops when the vacuum reaches the set vacuum degree and automatically starts when the vacuum is lower than the lower limit so that it can work in a cycle to achieve the required vacuum;
5. Pressure relief method: manually decompress after the test or when taking the product;
6. Machine vacuum degree range: 0 to -98.0KPa; different regions show different vacuum degrees;
7. Pressure display mode: It is a relative display. If the vacuum is 11.6KPa, the standard air pressure is 101.3KPa-11.6KPa=89.1KPa, the vacuum gauge is set to -89.7KPa and the set data is drawn pressure, other parameters are calculated and set by the same;
8. Leakage rate of vacuum holding pressure: 0.8KPa/hour;
9. Vacuum pump configuration: VP-1 direct-connected vacuum pump. (pictured)

Power of Vacuum Drying Oven

• 1. voltage: 380V 50Hz (can do customized too)
• 2. Circuit protection system: grounding protection, fast insurance, etc.