Testing standards
ASTM D6770, Federal Test Method STD No 191Am Method 5309
Ribbon Webbing Abrasion Tester Specification
1. Load: 2.3±0.05 kg
2. Roller: ￠400 mm
3. Drive mode: motor drive
4. Test fixture: 3 sets (according to the size of the webbing)
5. Friction Angle: 85±2°
6. Test stroke: 300±20 mm
7. Test speed: 30±2 times /min
8. Counting mode: touchscreen control
9. Hex bar: 6.35± 0.03mm, chamfer 0.5± 0.1mm
10. Machine size: 105*105*90cm
11. Weight: 198 kg
12. Power supply: AC220V, 60Hz, 800W, 4A
Detailed introduction of Ribbon Webbing Abrasion Test machine
1. PV: Displays the current test times in real-time
2. SV: Determine the number of tests
3. Speed: Displays the current test speed
4. Start-up, stop/reset: Start/stop the test
5. Check: The page for viewing groups is displayed
- Stop/Reset: The number of arrival stop mode/sample break stop modes can be selected.
- Clear All to zero: Clears three groups of count times.
- Entering setting
Operation Instruction of Ribbon Webbing Abrasion Testing machine
1. Place the machine in a horizontal position.
2. Connect the power cable and turn on the power switch.
3. Set the required test parameters (frequency, speed)
4. Clamp the product to be tested
5. Press the test button to start the test
6. Automatically stop after reaching the set condition value
7. Take out the specimen and check the degree of damage to the test sample.
Maintenance of Ribbon Webbing Abrasion Test equipment
1. Pay attention to each key; gently press and release.
2. When the machine is working, the power should be grounded with three plugs and cut off when it is not working.
3. We should place the machine in the laboratory, and keep the ground dry and smooth.
